2Pcs Single Spray Humidifieration Module DIY Atomization Disc with DC4.5V 3 Cell Plastic Case Box, also supports Type-C Interface (Two Types Power Supply Methods)

SPECIFICATIONS: Humidifier Module Parameter: Rated Voltage: DC 5V Rated Current: 300mA Two Types Power Supply Methods: Type-C socket or Red PH2.0 terminal socket connect battery holder case Humidifier Interface: White PH2.0 terminal Material: 1.2mm FR-4 PCB Size: 35*19mm, Weight: 4g Frequency: 108KHz+3 Power: 1.5-2W Atomization amount: Around 40-50ml/h Work Temperature: 0℃~85℃ Work Humidity: 10%~90%RH Microporous Atomizing Film Parameter: Steel Sheet Diameter: 16mm Outer Diameter of Silicone Ring: 20mm Cable Length: 100mm Weight: 2g Frequency: 108KHz+3 Aperture: 4-5μm Number of Holes: 740 holes Interface: White PH2.0 terminal Material: Piezo ceramic ring + Stainless steel Humidifier Cotton Swab Size: 100*10mm Black Bracket Size: 38*24mm, Weight: 4g Battery Holder Case Parameter: Rated Voltage: 4.5V (3 cells AA battery, battery not included) Battery Case Interface: Red PH2.0 terminal Wire Length: 150mm Size: 57*47*15mm, Weight: 10g DIRECTIONS FOR USE: 1. Attach the atomizer to the circuit board. 2. USB DC 5V power supply. 3. Press the circuit board switch. 4. Atomizing plate suction water spray. NOTE: 1. Do not puncture the atomizer. 2. Can not run empty. 3. Do not use fast chargers. 4. No change circuit. 5. The circuit board must not be damp. 6. All steel sides absorb water downward. 7. Rated power input. Package Inlcuding: 2 X Atomization Module Type-C Interface 2 X Microporous Atomizing Film 2 X Humidifier Cotton Swab 2 X Black Plastic Bracket 2 X 3Cell Battery Holder Case

• High-frequency oscillation, micrometer aperture, large atomization amount, fine mist particles, high spray rate, spray variety, timed shutdown. Note: The atomizing piece needs to be used together with the circuit board with the same frequency to achieve the ideal spray amount.
• Two spray modes: ①press the switch for the first time is continuous spray mode: LED light is always on, always spray, spray 4 hours after the automatic shutdown protection. ②Press the switch for the second time is intermittent spray mode: 10 seconds spray and 5 seconds pause, in sequence loop, spray 12 hours after the automatic shutdown protection. Press the switch for the third time to turn off the machine.
• Pay attention to both sides of the atomizing sheet: The white piezoelectric ceramic ring surface is the front spray surface, which is installed upward, All steel sheet surface is the suction surface on the back, installed downwards. If the installation is reversed, it will not be able to spray. The red wire is positive and the black wire is negative.
• How to use: 1. First install the atomizer plate, holder, cotton swab. 2. Connect the atomizer plate to the module port (White PH2.0 terminal). 3. Connect the power supply to the module power port (Type-C socket or Red PH2.0 terminal socket connect battery holder case). 4. Press the power switch. 5. The atomizer plate will spray when it comes into contact with water.
• Spray Principle: Piezoelectric ceramics drive metal plate high-frequency oscillation, ultrasonic liquid atomization. Micrometer-fine water molecules atomize water throughmicropores and disperse it into the air. Application: DIY spray, plant hydration humidification, landscaping atomization.